Navigation Menu New

Access My Account, Order History, Lists and more here.

4AZU7 1000019R4XXXA UNSPSC # 31162403

Tap image to zoom.

Roll over image to zoom.

Right Hand Pivot Hinge With Holes, Full Mortise Mounting, Satin Chrome Finish

  • Item # 4AZU7
  • Mfr. Model # 1000019R4XXXA
  • UNSPSC # 31162403
  • Catalog Page # N/A
Country of Origin USA. Country of Origin is subject to change.

Rixson full-mortise intermediate pivot hinge create less stress on the frame assembly to help prevent door sagging, maintain door alignment, and allow the door to swing with less resistance. Also reduces the likelihood of fasteners pulling out over time and aids with the installation of floor closers and bottom pivots.
• Right handed
• Not load-bearing
• 3/4" (19mm) offset
• Door edges must be beveled in 1/8" in 2"
• Includes wood screws and machine screws

Note: On labeled fire door assemblies, NFPA80 requires an intermediate pivot for every additional 30"(762mm) (or fraction thereof) of door height over 60"(1524mm).

Technical Specs

  • Item Pivot Hinge
  • Material Brass
  • Finish Satin Chrome
  • Load Capacity 250.0 lb
  • Holes With
  • Holes per Leaf 5
  • Ligature Resistant No
  • Range of Motion 180 Degrees
  • Orientation Right Hand
  • Required Door Thickness 1 3/4 in
  • Bearing Type Bushing
  • Corners Square
  • Hardware Included
  • Mounting Full Mortise
  • Pin Material Hardened Steel
  • Pin Type Nonremovable
  • Standards BHMA/ANSI NO: C07162
  • Door Leaf Height 5 in
  • Door Leaf Width 1 1/8 in
  • Frame Leaf Height 5 in

Rixson full-mortise intermediate pivot hinge create less stress on the frame assembly to help prevent door sagging, maintain door alignment, and allow the door to swing with less resistance. Also reduces the likelihood of fasteners pulling out over time and aids with the installation of floor closers and bottom pivots.
• Right handed
• Not load-bearing
• 3/4" (19mm) offset
• Door edges must be beveled in 1/8" in 2"
• Includes wood screws and machine screws

Note: On labeled fire door assemblies, NFPA80 requires an intermediate pivot for every additional 30"(762mm) (or fraction thereof) of door height over 60"(1524mm).

Back to Top